Yaskawa Varispeed-656 DC5 Converter - Manual (Page 12)

VS-656DC5 User’s Manual
10 - 20
5. Digital operator (JVOP-132) Description
Mode Display LEDs
(All LEDs will flash when an error occurs in drive mode)
Drive Mode Display
Flashes upon drive mode selection. Off in program mode
selection
Direction Display
FWD: Unused
REV: Unused
Remote Mode
Control by control circuit terminals and option card mode.
SEQ: Flashes when the run command is by remote mode
selection
REF: Unused
Display
Displays the monitor values for output voltage, output current,
etc., as well as settings for the various functions. (5 digit)
Mode Selection Key
Switches between drive mode and program mode (enabled dur-
ing operation). The drive mode display light will flash while in
drive mode.
Display Selection Key
Selects the display type. (procedure is shown on the following
page)
Read/Write Key
Displays the setting for each parameter. After setting, write the
setting by pressing this key again.
Number Change Keys
These change the numerical values of settings, parameters, etc.
: Increment Key
V: Decrement Key
V
Digit Selection Key
This selects the digit of a setting value to be changed. The
selected digit will flash
(This becomes the Reset key in an error display)
Run Command Key
Run command key when operating with the digital operator. It
is enabled only in the drive mode.
• STOP : Stop Command
The red lamp on the right will light when STOP is
pressed.
• RUN : Run Command
The red lamp on the left will light when RUN is
FWD/REV: Unused
JOG: Unused
Run Mode Selection Key
This switches the run mode between REMOTE and LOCAL
(digital operator).