Yaskawa MP2600iec - Manual (Page 10)

2.2 MP2600iec Hardware Specifications
8
2.2 MP2600iec Hardware Specifications
* Allocated I/O can also be used as programmable I/O if the output functions are disabled.
Item Specification
CPU 200 MHz, 32 bit, ARM 9
Memory
SDRAM 32 MB
SRAM 512 kB with battery backup
Flash 4 MB flash. Code and parameter storage.
Operator interface
LED
10 LEDs (red and green - operating mode,
communication and error status)
User Configuration
6x DIP switch (operating mode and communication
configuration)
User
I/O
Controller
Side
(CN13)
Network 2x 100baseTX Ethernet
Digital input 8 programmable inputs
Digital output 8 programmable outputs
Analog input 1 ch., +/- 10V, 16 bit
Analog output 1 ch., +/- 10V, 16 bit
Pulse Counter
RS-422-compatible pulse counter input (quadrature,
pulse and direction, and up/down counter modes) with
5, 12, or 24V position latch input
Servo-
Side
(CN1)
Sequence
Input
Allocated*
Number of Inputs: 7
Functions: The signal allocation and positive/negative
logic can be modified. Forward run
prohibited (P-OT),
reverse run prohibited (N-OT), forward torque limit (/P-
CL), reverse torque limit (/N-CL), general-purpose
input signal (/SI0 to /SI6)
Sequence
Output
Fixed Servo Alarm (ALM)
Allocated*
Number of Outputs: 3
Functions: The signal allocation and positive/negative
logic can be modified. Positioning completion (/COIN),
speed
coincidence detection(/V-CMP), servomotor
rotation detection (/TGON), servo ready (/S-RDY),
torque limit detection
(/CLT), speed limit detection
(VLT), brake (/BK), warning (/WARN), near (/NEAR)
Network capability
OPC (Client and Server required)
EtherNet/IP
Modbus/TCP
Programming standards IEC61131-3/PLCopen
Diagnostic and configuration interface Web interface
Motion control performance
1 controlled axis and one external position input at a
trajectory update rate of 1 kHz
Servo-Side Safety Functions
Input
/HWBB1, /HWBB2: Baseblock signal for power
module
Output
EDM1: Status monitor (fixed output) of built-in safety
circuit