Yaskawa Σ-II Series - Manual (Page 26)

E-22
6 INSPECTION AND MAINTENANCE
This section describes the basic inspections and maintenance. If any failure occures on SER-
VOPACK, refer to
Σ-II Series SGM H/SGDH User’s Manual Design and Maintenace Section
10.2 Troubleshooting (SIE-S800-32.2) and Σ-II Series SGDH MECHATROLINK Interface
Module User’s Manual (SIE-C718-4). Contact your Yaskawa representative if the problem can-
not be solved by the procedures described.
• Be sure to turn OFF power before inspection or maintenance.
Otherwise, electric shock may result.
• Never open the terminal cover while power is ON, and never turn ON power when the terminal
cover is open.
Otherwise, electric shock may result.
• After turning OFF power, wait at least five minutes before servicing the product.
Otherwise, residual electric charges may result in electric shock.
• Never change wiring while power is ON.
Failure to observe this caution may result in electric shock or personal injury.
WARNING
CAUTION