6 option related drive parameters – Yaskawa SI-EP3 PROFINET Installation User Manual
Page 26

6 Option Related Drive Parameters
26
YASKAWA TOEP YEACOM 07A 1000-Series Option PROFINET SI-EP3 Installation Manual
F7-33
to
F7-37
Dynamic Input
Assembly
Parameters
(SI-EP3 Firmware
Version VST800250)
Configurable inputs 1 to 5.
If a value other than 0 is assigned to parameters F7-23 to
F7-27 and F7-33 to F7-37 by the drive, that value will take
precedent over a value set by the configuration software.
If the value in the drive is 0 (default), the value from the
configuration software will be used.
0
Dynamic Input
Assembly
Parameters
(SI-EP3 Firmware
Version VST800251)
Configurable outputs 1 to 5.
If a value other than 0 is assigned in the configuration
software, those values will be used, otherwise, the values of
the drive parameters set in parameters F7-23 to F7-27 and
F7-33 to F7-37 will be used.
H5-11
Communications
ENTER Function
Selection
Select the function for the ENTER command that saves
parameter data to the drive.
0: Parameter changes are activated when ENTER command
is written
1: Parameter changes are activated immediately without use
of ENTER command
1
<1> To start and stop the drive with the option master device using serial communications, set b1-02 to 3. To control
the drive frequency reference via the master device, set b1-01 to 3.
<2> If F6-01 is set to 3, 4, or 5, then the drive will continue to operate when a bUS fault is detected. Take proper safety
measures, such as installing an emergency stop switch.
<3> The availability of this feature/function is depends on drive model, software version and Profinet firmware
for specifics relating to your drive.
No.
Name
Description
Default