SMA SB 2000HF-US Installation - Manual (Page 16)

Installation SMA America, LLC
16 FMK20-30HFUS-eng-IUS111610 Installation Guide
4.4 Mounting the Installation Tray
Additional mounting material (not included in the scope of delivery):
• 10 screws with a maximum diameter of
5
⁄
16
in. (8 mm).
• At least 10 washers
1. Position the installation tray between two upright
profiles. While doing so, ensure that the installation
tray is level with the upright profiles.
2. Mark the position of the holes.
3. Drill the holes.
Selecting the installation height
So that the display of the inverter is at eye-level after mounting, mount the Flush‑Mount Kit with
its lower edge about 3 ft. 3 in. (approx. 1 000 mm) above the ground.