ShoreLand'r SRB68TCBB - Manual (Page 9)

Roller Arm Assembly
Locate the support arms bundle. Place one of the
arms into the factory installed mounting bracket on
the rear pivot with the ends curved up as shown
on page 2. Secure in the bracket with two (2) 1/2”
x 4” carriage bolts and hex lock nuts. Tighten.
Place one of the roller assemblies on the end of
the support arms just installed. Line up the hole in
the mounting bracket with the hole in the support
arm and secure with a 1/2” x 4-1/2” hex bolts and
of this support arm. Repeat this complete process
on the other support arm.
Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0004361
Page 9 of 14 4/29/2011