ShoreLand'r SRB68TCBB - Manual (Page 12)

assembly.
Then swing the front of the spring up and attach to the
front mounting hole in the spring bracket with another
9/16” x 3-1/4” hex bolt and lock nut.
Tighten all axle U-bolts and spring bolts not tightened
at this time.
Brake Line Installation
Locate line clamps and 1/4” self tapping screws
provided in the kit. Thread the hose into the hole on
the bottom of the brass block on the right brake
calipers. Form the hose so that it can be placed in a
clip and attached to the spring plate with a #10-32 X1
machine screw, washers and a 10-32 hex nut to keep
it up in place under the leaf springs.
Route the hose along the back side of the axle and secure to
the axle with the five (5) clamps and self tapping screws. Note
that the axle is pre-drilled for the mounting screws.
Remove the plastic plug from the port in the brass block on
the left brake caliper. Thread the brake hose fitting into this
port place in a clip and attached to the spring plate with #10-
32 X1 machine screw, washers and a 10-32 hex nut to hold
the hose in position making sure that it does not rub or touch
the spring. Tighten all fittings.
Repeat this process on the second axle.
Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0004361
Page 12 of 14 4/29/2011