ShoreLand'r SRB68TCBB User Manual
Page 7
Midwest Industries, Inc.
Ida Grove, IA 51445
800.859.3028
www.shorelandr.com
0004361
Page 7 of 14
4/29/2011
RB Bunk Assembly
Locate the support arms bundle. Place
one of the arms into the factory installed
mounting bracket on the rear pivot with the
ends curved up as shown. Secure in the
bracket with two (2) 1/2” x 4” carriage bolts
and hex lock nuts. See Detail B. Tighten.
Place one of the bunk assemblies on the
end of the support arms just installed. Line
up the top hole in the mounting bracket
with the hole in the support arm and
secure with a 1/2” x 4-1/2” hex bolts and
hex lock nuts. Tighten. Repeat on the
other end of this support arm. Repeat this
complete process on the other support
arm.
Note that the bunk assemblies have two
height adjustments. The instructions are to
install them in the lowest position to keep
the center of gravity as low as possible for
towing. If required for fender clearance,
the bunks can be installed in the raised
position by mounting the bunk assemblies
to the bunk support arms using the lower
mounting hole.