ShoreLand'r SRB68TCBB User Manual
Page 4
![background image](https://www.manualsdir.com/files/818044/content/doc004.png)
Tongue
The tongue comes shipped separately. Locate and install
under the frames front tongue channel and in the channel
welded to the front cross member which will support the
rear of the tongue.
Align the hole in the tongue with the hole in the tongue
channel. Install the 1/2” x 4” carriage bolt in the front hole
and secure with a 1/2” lock nut. Secure the rear of the
tongue to the frame with a 1/2” x 4” carriage bolt and lock
nut. Tighten.
Tongue Wire Harness
Locate the tongue wire harness. Place the end of the wire
harness with the two three wire triangular plugs into the
hole in the top of the tongue. Pull backwards through the
tongue until they can be fished through the holes in each
side of the tongue. Note that the brown, white, and yellow
harness must go to the left side of the trailer and the
brown, white, and green harness must go to the right side
of the trailer.
Plug the tongue wire harness ends into the frame
harnesses by matching colors and ends. Push the extra
wire provided, either into the hole in the tongue or else
remove the grommet in the side frame and place the extra
wire in the side frame. Place grommets into all the wire
holes. Replace grommets just removed from the side
frames.
Safety Chains
Mount the safety chains to the front of the tongue by
placing a 1/2” flat washer onto a 1/2” x 1 1/2” hex bolt, and
then insert the bolt through the last link on one of the
safety chains provided. Insert the bolt through the hole
provided in the front of the tongue as shown. Secure with
a 1/2” hex flange lock nut. Repeat the process on the
other chain. Tighten.
Actuator
Locate the actuator, and position it on the front of the
tongue as shown. Look into the back end of the actuator
and locate the solenoid. Note there is a wire harness
coiled around the round solenoid. Uncoil the wire and
plug it into the bullet plug on the end of the blue wire of
the tongue harness. Remove the plastic plug from the
port in the rear of the solenoid. Thread the fitting on the
Midwest Industries, Inc.
Ida Grove, IA 51445
800.859.3028
www.shorelandr.com
0004361
Page 4 of 14
4/29/2011