ShoreLand'r SL30BAL - Manual (Page 5)

Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 www.shorelandr.com M301237
REV A 9/18/03
Page 5
One Axle Brake Installation
Cut the tape securing the brake line hose to the axle. Remove the brass
plug from the port in the brass block on the right brake caliper. Thread in
the male end of the brake hose and tighten. Place the other end of the
hose through the hole in the brake line clip bracket and secure with a hose
clip.
Remove the plastic cap from the end of the frame brake line. This brake
line is located coming out of the black plastic tube in the side frame by the
axle.
Uncoil the brake line so that it reaches the end of the hose just attached to
the brake line clip bracket. Thread the brake line fitting into the brake line
hose. Tighten. NOTE: All bleeding to the line can be done through the
bleeder on the right caliper.
Fill the actuator reservoir with brake fluid and bleed the line per the
instructions in the Brake Manual. NOTE: The axle is already bled at the
factory during assembly. All bleeding to the line can be done through the
bleeder on the right caliper.
For bleeding instructions see the ShoreLand’r Disc
Brake Manual.
Tire And Wheel Assemblies
Mount the tire and wheel assemblies using the
1/2” fine threaded tapered lug nuts provided.
Tighten to 80-90 ft/lb. of torque using the
rotation pattern as shown in the ShoreLandr’s
Owners Manual.
Re-torque the lug nuts after 50 miles of driving
and then periodically thereafter.