ShoreLand'r SL30BAL - Manual (Page 2)

Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 www.shorelandr.com M301237
REV A 9/18/03
Page 2
Bunk Assembly (B-Series) - Assemble after the axles and tires are assembled.
The 2 x 6 bunk assemblies with mounting brackets are factory assembled. Place
the end of the bunk with the two brackets on the equiload bunk arm. Secure with a
3/8” x 1” hex bolt and lock nuts through the brackets on the bunk and the ear on
each end of the equiload arm. Repeat on the other end of the arm. (See Detail I.)
Place the other end of the bunk in the bracket and adjustable bracket mounted on
the front cross member. (The adjustable bracket is adjustable in height.) Once the
proper position for the rear cross member is determined, the front of the bunk
attaches to the bracket using two No. 10 x 1-1/4” self tapping screws as shown in
Detail H.
The 3/8” bolts can be tightened, do not over tighten. The bunks should be allowed
to rotate slightly to conform to the boat bottom.
IMPORTANT: All hardware for
your trailer is stainless steel.
It is important that you use an
anti-seize material on the bolt
threads when assembling to
prevent gaulding.