ShoreLand'r SL60T - Manual (Page 6)

Made in the USA Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 0002998
Page 6 www.shorelandr.com REV 02/08/01
Mount the actuator (Ref#10) on the drop
the tongue using two (2) 1/2” X 4-1/2” hex
bolts (Ref#3) and 1/2” stainless steel hex
lock nuts with nylon inserts (Ref#7).
Actuator:
Safety Chain:
Cylinoid:
Locate the cylinoid in the brakeline kit for
first axle (66801). Insert the cylinoid into the
rear of the actuator. Connect the brakeline
from the tongue to the cylinoid.
Mount the safety chains to the front on the
tongue using a 1/2” X 5-1/2” hex bolt
(Ref#4) with a 1/2” stainless steel flat
washer at the head of the bolt, followed by
a safety chain through the drop tongue tube.
Place the other safety chain on the bolt on
the opposite side of tongue and secure with
a 1/2” stainless steel flat washer and 1/2”
stainless steel hex lock nut with nylon in-
sert.
Brakeline:
Run the brakeline through the end of the
tongue and up through the second wire hole
on top of the tongue as shown in drawing.
Insert grommet.