ShoreLand'r SLB30BAL - Manual (Page 8)

Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004297
Page 8 of 11 2/09/2011
together using the 42” brake hose. Thread one end of the hose into the remaining port in the
brass tee. Route the hose over to and thru the brake line clip above the other axle. Connect
the other end into the side port of the right caliper on the second axle. Place a grommet around
the hose and insert into the brake line clip. To keep excess line up out of the way make a loop
in the 42” line and secure to the side frame with the clips included in the kit.
Fill the actuator reservoir with brake fluid and bleed the line per the instructions in the
ShoreLand’r Disc Brake Manual. Bleeding the system should be done through the bleeder
on the left caliper.
BUNK ASSEMBLY
Locate the two 2 x 6 bunk assemblies. Note that the bunk mounting brackets are assembled at
factory. Place the end with the two brackets towards the rear of the trailer. Place the assembly
on the equiload bunk arm and secure by placing a 3/8” x 1” hex bolt through the bracket on the
bunk and the ear on each end of the equiload arm. Secure in place using a 3/8” lock nut.
Repeat on the other end of the arm.
Frame
Brake
Hose
Attaches
Here