ShoreLand'r SLB30BAL User Manual
Page 5
Safety Chains
Place 1/2” x 5” hex bolt through a 1/2” flat washer and the
last link of the safety chains. Insert in the hole (bottom
front of the actuator) on the tongue. Place the second
chain on the same bolt that is extending through the other
side of the tongue. Secure with a 1/2” flat washer and hex
lock nut.
Brake Line
Locate the brass brake line coupling. Remove the plastic
cap and thread the brake hose coming out the rear of the
tongue into one end of the coupling. With the coupling on
the tongue brake hose align these to the brake hose from
the side frame. Once aligned, thread the side frame brake
hose into the other end of the coupling. Tighten both lines
into the coupling. After bleeding the brake system if no
leaks appear slide connections back into the tongue.
Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028
www.shorelandr.com
0004297
Page
5
of
11
2/09/2011