HEIDENHAIN TNC 640 (34059x-01) - Manual (Page 539)

HEIDENHAIN TNC 640 539
1
8
.1 Mac
h
ine-Specific User P
a
ra
met
e
rs
Geometry filter for culling linear elements
Type of stretch filter
- Off: No filter active
- ShortCut: Omit individual points on a polygon
- Average: The geometry filter smoothes corners
Maximum distance of the filtered to the unfiltered contour
0 to 10 [mm]: The filtered points lie within this tolerance to the resulting new path
Maximum length of the distance resulting from filtering
0 to 1000 [mm]: Length over which geometry filtering is active
Settings for the NC editor
Generate backup files
TRUE: Generate backup file after editing NC programs
FALSE: Do not generate backup file after editing NC programs
Behavior of the cursor after deletion of lines
TRUE: Cursor is placed on the preceding line after deletion (iTNC behavior)
FALSE: Cursor is placed on the following line after deletion
Behavior of the cursor on the first or last line
TRUE: Cursor jumps from end to beginning of program
FALSE: Cursor does not jump from end to beginning of program
Line break with multiline blocks
ALL: Always display all lines
ACT: Only display the lines of the active block completely
NO: Only display all lines when block is edited
Activate help
TRUE: Always display help graphics during input
FALSE: Only display help graphics when the CYCLE HELP soft key is set to ON. The CYCLE HELP OFF/ON
soft key is displayed in Programming operating mode after pressing the "Screen layout" key
Behavior of the soft-key row after a cycle entry
TRUE: The cycle soft-key row remains active after a cycle definition
FALSE: The cycle soft-key row is hidden after a cycle definition
Safety check when deleting blocks
TRUE: Display confirmation question when deleting an NC block
FALSE: Do not display confirmation question when deleting an NC block
Line number up to which a test of the NC program is to be run
100 to 9999: Program length for which the geometry is to be checked
DIN/ISO programming: Block number increment
0 to 250: Increments for creation of DIN/ISO blocks in the program
Line number to which identical syntax elements are searched for
500 tp 9999: Search for cursored elements with up / down arrow keys
Paths for the end user
List of drives and/or directories
Drives or directories entered here are shown in the TNC’s file manager
FN 16 output path for execution
Path for FN 16 output when no path is defined in the program
FN 16 output path for the Programming and Test Run op. modes
Path for FN 16 output when no path is defined in the program
Universal Time (Greenwich Mean Time)
Time difference to universal time [h]
–12 to 13: Time difference in hours relative to Greenwich Mean Time
Parameter settings