HEIDENHAIN TNC 640 (34059x-01) User Manual
Page 28
28
14.1 Switch-On, Switch-Off ..... 438
14.2 Moving the Machine Axes ..... 441
Moving the axis using the machine axis direction buttons ..... 441
Incremental jog positioning ..... 442
Traversing with the HR 410 electronic handwheel ..... 443
14.3 Spindle Speed S, Feed Rate F and Miscellaneous Functions M ..... 444
Changing the spindle speed and feed rate ..... 445
Activating feed-rate limitation ..... 446
14.4 Datum Setting without a 3-D Touch Probe ..... 447
Workpiece presetting with axis keys ..... 448
Datum management with the preset table ..... 449
14.5 Using the 3-D Touch Probe ..... 455
Selecting touch probe cycles ..... 455
Writing the measured values from touch probe cycles in datum tables ..... 456
Writing the measured values from touch probe cycles in the preset table ..... 456
14.6 Calibrating a 3-D Touch Probe ..... 457
Calibrating the effective length ..... 458
Calibrating the effective radius and compensating center misalignment ..... 459
Displaying calibration values ..... 460
14.7 Compensating Workpiece Misalignment with a 3-D Touch Probe ..... 461
Measuring a basic rotation ..... 462
Saving a basic rotation in the preset table ..... 462
Displaying a basic rotation ..... 462