HEIDENHAIN TNC 640 (34059x-01) - Manual (Page 422)

422 Programming: Turning Operations
13.2 Basis F
unctions (Sof
tw
ar
e Option 50)
Data in the turning tool table
:
Abbr. Application Input
T Tool number: Must match the tool number of the turning tool in
TOOL.T -
ZL Compensation value for tool length 1 (Z direction) -99999.9999...+99999.9999
XL Compensation value for tool length 2 (X direction) -99999.9999...+99999.9999
DZL Delta value for tool length 1 (Z direction), additive effect on ZL -99999.9999...+99999.9999
DXL Delta value for tool length 2 (X direction), additive effect on XL -99999.9999...+99999.9999
RS Tool tip radius: The TNC considers the tool tip radius in turning
cycles and implements tool tip radius compensation when
contours with radius compensation RL or RR were programmed -99999.9999...+99999.9999
TO Tool orientation: Direction of tool tip 1...9
ANGLE OF
ORIENTATION
(ORI) Spindle orientation angle: Angle of the milling spindle for aligning
the turning tool to the machining position -360.0...+360.0
T-ANGLE Setting angle for roughing and finishing tools 0.0000...+179.9999
P-ANGLE Point angle for roughing and finishing tools 0.0000...+179.9999
CUTWIDTH Width of recessing tool -99999.9999...+99999.9999
TYPE Type of turning tool: Roughing tool ROUGH, finishing tool FINISH,
thread tool THREAD, recessing tool RECESS, button tool BUTTON ROUGH, FINISH, THREAD, RECESS,
BUTTON