Operating instructions – Enviro Meridian C-10135 User Manual
Page 6
Your pellet Stove has the following safety features:
A) The stove will shut off when the fire goes out and the exhaust temperature drops below 120°F (49°C).
B) The stove has a high temperature safety switch. If the temperature on the hopper reaches 200°F (93°C)
the auger will automatically stop, and the stove will shut off when the exhaust temperature cools. If this
happens call your local dealer to reset the 200°F (93°C) high limit switch. FIND THE REASONS WHY THE UNIT
OVERHEATED.
HEAT LEVEL INDICATOR:
Shows the Heat Level output setting.
HEAT LEVEL ADJUSTMENT:
This button will change the Heat Level output
setting of the stove from low to high
ON/OFF BUTTON:
Is used to turn the unit ON and OFF
SYSTEM LIGHT:
The System Light is responsible for signaling the state of
the control board. When the light is flashing during start-up, the stove is in an
automatic start mode. When the light is solid, the Heat Level Setting can be
altered.
MANUAL AUGER FEED:
If the unit runs out of fuel this button can be used to
“prime the auger system”. This button will turn off after 60 seconds and then must
be released, then pressed again
.
AUGER LIGHT:
This light will flash when the auger motor is energized.
CONVECTION BLOWER CONTROL:
Used to turn the convection blower ON/
OFF. If the Blower is left off, and the sensor located on the air jacket reaches 160°
F (71° C), the Convection blower will automatically come on HI speed to cool the
unit. Leave the convection blower ON for peak efficiency.
AUGER TRIM:
The Auger Trim Button is used to increase or decrease the feed
3 SECONDS “ON”
Standard Setting
2 SECONDS “ON”
4 SECONDS “ON”
rate on LOW, ONLY. Push the Auger Trim button until the number 1 and 5 lights appear on the Heat Level Indicator.
This will increase the feed rate to 4 seconds ON time Auger pulse. This is done only on LOW to allow the burning
of poor quality fuels. Push the button until the number 1 and 4 lights appear, this will reduce the Auger On time to
2 second. This setting is for high-grade fuel only. Push the button until just the number 1 light is on, this is for a
3 second on time (standard setting).
S
TOVE
C
ONTROLS
:
A
UTOMATIC
S
AFETY
F
EATURES
:
Operating Instructions
6