HEIDENHAIN TNC 620 (73498x-01) ISO programming - Manual (Page 444)

444 Tables and overviews
1
7.1 Mac
h
ine-specific user par
a
met
e
rs
ChannelSettings
CH_NC
Active kinematics
Kinematics to be activated
List of machine kinematics
Geometry tolerances
Permissible deviation from the radius
0.0001 to 0.016 [mm]: Permissible deviation of the radius at the circle end-point compared with
the circle start-point
Configuration of the fixed cycles
Overlap factor for pocket milling
0.001 to 1.414: Overlap factor for Cycle 4 POCKET MILLING and Cycle 5 CIRCULAR POCKET
MILLING
Display the "Spindle?" error message if M3/M4 is not active
On: Issue error message
Off: No error message
Display the "Enter a negative depth" error message
On: Issue error message
Off: No error message
Behavior when moving to wall of slot in the cylinder surface
LineNormal. Approach on a straight line
CircleTangential: Approach on a circular path
M function for spindle orientation
–1: Spindle orientation directly by the NC
0: Function inactive
1 to 999: Number of the M function for spindle orientation
Parameter settings