HEIDENHAIN TNC 320 (340 55x-05) - Manual (Page 64)

64 Introduction
2.3 Oper
ating Modes
Program Run, Full Sequence and Program Run,
Single Block
In the Program Run, Full Sequence mode of operation the TNC
executes a part program continuously to its end or to a manual or
programmed stop. You can resume program run after an interruption.
In the Program Run, Single Block mode of operation you execute each
block separately by pressing the machine START button.
Soft keys for selecting the screen layout
Window Soft key
Program
Left: program, right: program structure
Left: program, right: status
Left: program blocks, right: graphics
Graphics