HEIDENHAIN TNC 320 (340 55x-05) - Manual (Page 497)

HEIDENHAIN TNC 320 497
Handling of error messages:
„ Help for error messages „ Call via ERR key „ Call via HELP key
„ Help for error messages while a block
is being edited „ Cause and corrective action cannot be
displayed while highlight is on the
block „ Pop-up window shows cause and
corrective action
„ Switching the operating mode while
help menu is active „ Help menu is closed when the
operating mode is switched „ Operating mode switchover is not
allowed (key is non-functional)
„ Selecting the background operating
mode while help menu is active „ Help menu is closed when F12 is used
for switching „ Help menu remains open when F12 is
used for switching
„ Identical error messages „ Are collected in a list „ Are displayed only once
„ Acknowledgment of error messages „ Every error message (even if it is
displayed more than once) must be
acknowledged, the Delete all
function is available „ Error message to be acknowledged
only once
„ Access to protocol functions „ Log and powerful filter functions
(errors, keystrokes) are available „ Complete log without filter functions
available
„ Saving service files „ Available. No service file is created
when the system crashes „ Available. A service file is
automatically created when the
system crashes
Find function:
„ List of words recently searched for „ Not available „ Available
„ Show elements of active block „ Not available „ Available
„ Show list of all available NC blocks „ Not available „ Available
Starting the find function with the
up/down arrow keys when highlight is
on a block Works with max. 9999 blocks, can be
set via config datum No limitation regarding program length
Programming graphics:
„ Depiction of the traverse paths of an
individual NC block after the graphic
was deleted by soft key „ Not possible; after pressing CLEAR
GRAPHIC soft key, all previously
defined NC blocks are displayed „ Available
„ True-to-scale display of grid „ Available „ Not available
„ Editing contour subprograms in SLII
cycles with AUTO DRAW ON „ If error messages occur, the cursor is
on the CYCL CALL block in the main
program „ If error messages occur, the cursor is
on the error-causing block in the
contour subprogram
„ Moving the zoom window „ Repeat function not available „ Repeat function available
Programming minor axes:
„ Syntax FUNCTION PARAXCOMP: Define
the behavior of the display and the
paths of traverse „ Available „ Not available
„ Syntax FUNCTION PARAXMODE: Define
the assignment of the parallel axes to
be traversed „ Available „ Not available
Function TNC 320 iTNC 530