HEIDENHAIN ND 1300 Addendum - Manual (Page 17)

ND 1300 QUADRA-CHEK 17
2.1 Oper
ation
@QUIT Key QUIT
@CANCEL Key CANCEL
@PRINT Key PRINT
@WIDE1 Key WIDE1
@WIDE2 Key WIDE2
@REMOTE0 Remote keypad 0
@REMOTE1 Remote keypad 1
@REMOTE2 Remote keypad 2
@REMOTE3 Remote keypad 3
@REMOTE4 Remote keypad 4
@REMOTE5 Remote keypad 5
@REMOTE6 Remote keypad 6
@REMOTE7 Remote keypad 7
@REMOTE8 Remote keypad 8
@REMOTE9 Remote keypad 9
@REMOTE . Remote keypad .
@REMOTE + Remote keypad +
@REMOTE - Remote keypad -
@REMOTE ENTER Remote keypad ENTER
@REMOTE FINISH Remote keypad FINISH
BEEP Make Beep sound.
HELP Prints available remote commands with syntax.
S or s Sends the current DRO position in the format (D,
X value, Y value, Z value). In case there is no Z axis,
the Z value is set to 0. In a system with a probe the
format is temporarily changed to show the last
position where a probe hit occurred (A, X probe
value, Y probe value, Z probe value). This only
happens the first time the S or s command is sent
after a probe hit occurs.
VERSION Prints the unit system name and software version.
Command Function