HEIDENHAIN ND 1300 Addendum - Manual (Page 11)

ND 1300 QUADRA-CHEK 11
1.
1
S
e
tu
p Extra Tab Functions
Extra tab functions are added to the Extra tab in the Display setup
screen. A description for each function is provided in the table below.
The functions that are available depends on the system configuration.
Not all functions listed may be available on your system. Refer to
“Configuring the Extra tab” and “Sending data using the Extra tab” in
the User’s Guide for additional information.
Icon Name Description
Space Inserts a blank space for separating function icons into groups.
Divider Inserts a vertical dividing line for separating function icons into groups.
Send X Sends the X value for the selected features.
When no features are selected, the X value of the DRO (if the display is in Cartesian coordinates),
or the R value of the DRO (if the display is in Polar coordinates) is sent.
Send Y Sends the Y value for the selected features.
When no features are selected, the Y value of the DRO (if the display is in Cartesian coordinates),
or the Theta value of the DRO (if the display is in Polar coordinates) is sent.
Send Z Sends the Z value for the selected features.
When no features are selected, the Z position of the DRO is sent.
Send Q Sends the Q position for the DRO.
Send r Sends the radius value for the selected features.
Send D Sends the diameter value for the selected features.
Send L Sends the length value for the selected features.
Send W Sends the width value for the selected features.
Send Theta Sends the angle value for the selected features.