HEIDENHAIN ND 1300 Addendum - Manual (Page 13)

ND 1300 QUADRA-CHEK 13
1.
1
S
e
tu
p
Motor On Toggles the motor enable on and off. The icon displays the current state.
Goto
Selected Initiates a CNC move to the selected feature.
Auto Focus Performs a VED auto focus.
Goto Brings up the goto position dialog box (shown below) and initiates a CNC move to the specified
position.
Send Two Sends the X and Y values for the selected features.
When no features are selected, the X value and the Y value of the DRO (if the display is in
Cartesian coordinates), or the R value and the Theta value of the DRO (if the display is in Polar
coordinates) are sent.
Zero Two When a feature is selected the DRO will be zeroed based on the feature’s X and Y position. This
will only work for the currently selected feature, not for multiple selected features.
When no feature is present the DRO will be zeroed at the current location.
Jog Up While pressed the Z axis of the CNC will be moved in the positive direction. This can be used in
place of a Z axis joystick control.
Jog Down While pressed the Z axis of the CNC will be moved in the negative direction. This can be used in
place of a Z axis joystick control.
DMS/DD Toggles the current angle display format between decimal-degrees and degrees-minutes-
seconds.
Icon Name Description