HEIDENHAIN ND 920 - Manual (Page 28)

28
Select special functions.
SPEC
FCT
Go to HOLE PATTERN .
HOLE PATTERN ?
ENT
Select HOLE PATTERN .
Go to LINEAR PATTERN .
LINEAR PATTERN ?
ENT
Select LINEAR PATTERN .
1ST HOLE X =
Enter X coordinate of first hole (e.g. 20),
confirm with arrow down key.
HOLES PER ROW =
Enter the number of holes per row
(e.g. 4) and confirm with arrow down
key.
0 2
1ST HOLE Y =
Enter Y coordinate of first hole (e.g. 15),
confirm with arrow down key.
•
•
5 1
4
HOLE SPACING =
Enter the spacing between holes in the
row and confirm with the arrow down
key.
ANGLE =
HOLE DEPTH =
Enter the angle (e.g. 15 degrees) and
confirm with the arrow down key.
Enter the hole depth (e.g. -30 mm) and
confirm with the arrow down key.
•
•
•
6 1
1 5
3 0
Linear Hole Patterns