HEIDENHAIN ND 920 - Manual (Page 22)

22
Moving the Axes with the Distance-To-Go Display
Normally, the display shows the actual position of the tool. However, it
is often more helpful to display the remaining distance to the nominal
position (the distance-to-go). You can then position simply by moving
the axis until the display value is zero.
You can enter the absolute or the relative (incremental) coordinates in
the distance-to-go display. An active radius compensation will be
considered.
Example: Milling a shoulder with distance-to-go
Select the distance-to-go function.
The
∆
symbol lights up.
NOML. VALUE X =
Select the axis, enter the nominal value (for
example 20 mm), select radius compensation
R+ and confirm with ENT.
ENT
Y 0 2
Move the axis until the display value is zero 1.
•
•
•
Moving the Axes with Distance-To-Go
R +
-
Y
X
1 2
3 4
60 30
20
0
0
30
20