Polaris 2015 Ranger Diesel / Crew Diesel - Manual (Page 81)

79
MAINTENANCE
POLARIS Variable Transmission (PVT) System
Belt Replacement/Debris Removal
14. Reinstall the clutch cover in the reverse order of removal, fitting the top of the cover into
place, then working the bottom of the cover over the suspension.
15. Install all clutch cover screws.
Torque to 4-5 ft. lbs. (5.5-6.5 Nm).
PVT Drying
There may be some instances when water is accidently ingested into the PVT system. Use
the following instructions to dry it out before operating.
1. Position the vehicle on a level surface. Place the transmission in PARK. Stop the engine.
2. Remove the clutch cover drain plug. Allow the
water to drain completely. Reinstall the drain plug.
3. Start the engine.
4. Apply varying throttle for 10-15 seconds to expel
the moisture and air-dry the belt and clutches. Do
not apply heavy throttle for more than 10 seconds.
5. Allow the engine RPM to settle to idle speed.
Apply the brakes. Shift the transmission to the
lowest available range.
6. Test for belt slippage. If the belt slips, repeat the
process.
7. Take the vehicle to your dealer for service as soon as possible.
Step 13
Drain Plug