Polaris 2015 Ranger Diesel / Crew Diesel - Manual (Page 72)

70
MAINTENANCE
Engine Oil
Oil and Filter Change
Always change the oil and filter at the intervals outlined in the Periodic Maintenance Chart
beginning on page 65. Always change the oil filter whenever changing oil.
The crankcase drain plug is located on the bottom of the crankcase. Access the drain plug
through the access hole in the skid plate under the crankcase (see next page).
CAUTION! Always remove all cargo from the cargo box before lifting the box to access engine
components.
Access the oil fill cap, dipstick and filter under the cargo box.
1. Remove all cargo from the cargo box. See page 53.
2. Position the vehicle on a level surface.
3. Place the transmission in PARK.
4. Stand clear and pull up on the cargo box release lever. Lift the front of the cargo box.
5. Locate the crankcase drain plug access hole in the skid plate.
6. Clean the area around the crankcase drain plug.
CAUTION! Hot oil can cause burns to skin. Do not allow
hot oil to contact skin.
7. Place a drain pan under the engine crankcase and
remove the drain plug. Allow the oil to drain
completely.
8. Using an oil filter wrench, turn the filter counter-
clockwise to remove it.
9. Using a clean dry cloth, clean the filter sealing
surface on the crankcase.
10. Lubricate the o-ring on the new filter with a film
of fresh engine oil. Check to make sure the o-
ring is in good condition.
11. Install the new filter and turn by hand until the
filter gasket contacts the sealing surface, then
turn an additional 1/2 turn.
Crankcase
Drain Plug
Access
Hole
Bottom View of Skid Plate
Oil Fill
Cap
Oil
Filter
Oil
Dipstick