Polaris 2014 Ranger 800 EFI - Manual (Page 90)

88
MAINTENANCE
Battery
Battery Installation
Using a new battery that has not been fully charged can damage the battery and result in a
shorter life. It can also hinder vehicle performance. Follow the battery charging instructions
on page 89 before installing the battery.
1. Ensure that the battery is fully charged.
2. Place the fully charged battery in the
battery holder under the driver’s seat with
the terminals toward the rear of the
vehicle.
3. Connect and tighten the red (+) cable
first. Connect and tighten the black (-)
cable last.
4. Verify that cables are properly routed and
install the hold-down strap. Tighten the
screws securely.
Battery Storage
Whenever the vehicle is not used for a period of three months or more, remove the battery
from the vehicle, ensure that it's fully charged, and store it out of the sun in a cool, dry place.
Check battery voltage each month during storage and recharge as needed to maintain a full
charge. See page 89.
POLARIS recommends maintaining battery charge by using a POLARIS Battery Tender
charger or by charging about once a month to make up for normal self-discharge. Battery
Tender can be left connected during the storage period, and will automatically charge the
battery if the voltage drops below a pre-determined point.
Position Terminals
Toward Rear