Operation – Polaris 2001 Victory Standard Cruiser User Manual

Page 47

OPERATION

Starting and Warming up a Cold Engine

This motorcycle is equipped with a starter interlock system. The

engine can be started only under the following conditions:

The transmission is in neutral.

The transmission is in gear and the clutch disengaged

If the fuel indicator light comes on, check the fuel level and, if nec-

essary, add fuel.

Starting Procedure

1. Shift the transmission into neutral.

NOTE: When the transmission is in neutral, the neutral indica-

tor light should be on. If the light does not come on, ask a Victo-

ry dealer to inspect it.

2. Engage the fast idle lever by pulling the lever towards the rider

until the lever stops.

3. Turn the key to “ON” and ensure that the stop switch is in the

“RUN” position.

4. Start the engine by pushing the start switch.

5. The fast idle lever may be returned to the rest position as soon

as the engine has warmed sufficiently so it will idle smoothly.

NOTE: If the engine fails to start, release the start switch, wait a

few seconds, then try again. Each attempt should be as short as

possible to preserve the battery. Do not crank the engine more

than 10 seconds on any one attempt.
NOTE: The oil pressure light should come on when the start switch

is pushed and should go off when the start switch is released. If

the oil pressure light flickers or remains on, immediately stop the

engine and check the engine oil level and, if necessary, add oil.

Also check for oil leakage. If the oil pressure light still stays on,

consult your Victory dealer.

This manual is related to the following products: