Warnings, Avertissements – Grass Valley XG Vertigo Quick Start v.5.0 User Manual
Page 8
Warnings
A warning indicates a possible hazard to personnel, which may cause injury or
death. Observe the following general warnings when using or working on this
equipment:
•
Appropriately listed/certified mains supply power cords must be used for the
connection of the equipment to the mains voltage at either 120 V AC or 240 V AC.
•
This product relies on the building's installation for short-circuit (over-current)
protection. Ensure that a fuse or circuit breaker for 120 V AC or 240 V AC is used on
the phase conductors.
•
Any instructions in this manual that require opening the equipment cover or enclosure
are for use by qualified service personnel only.
•
Heed all warnings on the unit and in the operating instructions.
•
Do not use this equipment in or near water.
•
This equipment is grounded through the grounding conductor of the power cords. To
avoid electrical shock, plug the power cords into a properly wired receptacle before
connecting the equipment inputs or outputs.
•
Route power cords and other cables so they are not likely to be damaged.
•
Disconnect power before cleaning the equipment. Do not use liquid or aerosol
cleaners; use only a damp cloth.
•
Dangerous voltages may exist at several points in this equipment. To avoid injury, do
not touch exposed connections and components while power is on.
•
Do not wear rings or wristwatches when troubleshooting high current circuits such as
the power supplies.
•
To avoid fire hazard, use only the specified fuses with the correct type number, voltage
and current ratings as referenced in the appropriate locations in the service instructions
or on the equipment. Always refer fuse replacements to qualified service personnel.
•
To avoid explosion, do not operate this equipment in an explosive atmosphere.
•
This product includes a backup battery. There is a danger of explosion if the battery is
replaced incorrectly. Replace the battery only with the same or equivalent type
recommended by the manufacturer. Dispose of used batteries according to the
manufacturer’s instructions.
•
Have qualified service personnel perform safety checks after any service.
[fr]
Avertissements
•
Un cordon d’alimentation dûment homologué doit être utilisé pour connecter l’appareil
à une tension de secteur de 120 V CA ou 240 V CA.
•
La protection de ce produit contre les courts-circuits (surintensités) dépend de
l’installation électrique du bâtiment. Assurez-vous qu'un fusible ou un disjoncteur pour
120 V CA ou 240 V CA est utilisé sur les conducteurs de phase.