Grass Valley XG Vertigo Quick Start v.5.0 - Manual (Page 26)

Vertigo XG Installation & Quick Start Guide 2-1
2 I
NSTALLATION AND QUICK START
INSTRUCTIONS
This chapter provides you with instructions for performing a first-time installation of the
Vertigo XG device, as well as the initial setup tasks to get the device up and running. The
procedure concludes by verifying the installation by previewing the playout of an asset in
Vertigo XG’s Live Window and a broadcast monitor.
CAUTION
Vertigo XG devices should only be installed by trained personnel in a restricted access
locations only. All health and safety regulations and precautions must be observed.
The following table summarizes the tasks that you must perform to install and set up a brand
new, factory-configured Vertigo XG device.
Step # Task description
1
Unpack the parts included in the shipping package ( page 2-3 )
• Verify the completeness and condition of all of the items included in the shipping package
• Familiarize yourself with each of the items related to the Vertigo XG
2 Install the Vertigo XG chassis in a rack ( page 2-7 )
• Remove the faceplate from the Vertigo XG unit
• Install the rails on the side of the Vertigo XG unit and in the rack slot
• Mount the Vertigo XG unit in the rack and re-attach the faceplate
3 Cabling the Vertigo XG unit ( page 2-11 )
• Connect the power supply cables
• Connect the keyboard and mouse
• Connect the DVI monitor
• Connect the ethernet network cable(s)
• Connect the SDI video I/O cable
• Connect the discrete AES audio cable(s)
• Connect the automation system cable to the RS-232 / RS-422 ports
• Connect cable to time code card
• Connect cable to GPI card