Grass Valley XG Vertigo Quick Start v.5.0 - Manual (Page 33)

2-8 Vertigo XG Installation & Quick Start Guide
Installation and quick start instructions
To separate the sections of the rail assemblies:
1.
Locate the rail assemblies in the items shipped with the Vertigo XG.
2. Extend one of the rail assemblies by pulling it outward until the quick-release tab is
visible.
3. Press the quick-release tab to release the chassis rail from its locked position.
4. Separate the two rails by pulling the chassis rail from the rack rail assembly.
5. Repeat steps 2 to 4 for the other rail assembly.
Attaching the chassis rail to the Vertigo XG chassis
The chassis rails are attached and fixed to each side of the Vertigo XG chassis. Later when
mounting the chassis into the equipment rack, these rails will be inserted into the extension
rails of the rack rail assembly and securely lock the chassis to the equipment rack.
To install the chassis rails to the Vertigo XG chassis:
1.
Place the Vertigo XG unit on a solid, flat work surface.
2. Remove the Vertigo XG faceplate by pulling the faceplate’s handles away from the
chassis.
3. Place one of the chassis rails on the side of the chassis, ensuring that it is facing
“outwards” and that the hooks of the chassis with the rail’s holes.
4. Slide the rail toward the front of the chassis.
5. Secure the rail to the chassis with screws as illustrated below.
6. Repeat steps 3 and 5 for the other chassis rail.
Figure 2-2. Attaching the chassis rails to the Vertigo XG unit
3
4
5