Grass Valley Triton Plus Revision Video Routers 14 - Manual (Page 30)

30 Triton Plus - SD/3G-HD/HD -User Manual
Control Panel Operation
Panel Enable
The panel will start up in a disabled state. In this state the button will be red
and all the other buttons will be disabled. When pressing the button the
panel will be enabled and the color will change to green. A status request
will also be sent to get information on active levels.
Take On/Off
The Take On/Off button enables or disables the Take button. On first start-up
the Take button is enabled. Later it will read the last status from the flash
memory.
Take
The Take buttons LED is normally off. If the Take On/Off button is set to on, no
commands will be sent from the panel until the Take button is pressed. The
last selected buttons and the Take button will blink, until the Take button is
pressed and the command is sent from the panel.
Output
An Output button is used for selecting an output. Selecting an output acti-
vates it, so that it is switched to the next input that is selected.
Input
An Inpu t button switches the active output to the selected input. If the Take
button is enabled, the switch will not be executed until the Take button is
pressed.
When switching using the Input button, all enabled audio- and video-levels
will be switched from the selected input to the active output.
Note The Input button can also be used to select the active output. This is useful
on single bus panels. When the panel is enabled, press the Panel Enable
button and hold it while selecting the active output by pressing an Input
button. Then release the Panel Enable button. The panel will now be dis-
abled. Press the Panel Enable button again to enable it.