Grass Valley Triton Plus Revision Video Routers 14 - Manual (Page 23)

Triton Plus - SD/3G-HD/HD -User Manual 23
Configuration
Power Alarm
The power alarm can be switched with switch SW 7 according to the pattern
given in Table 28 . The default setting is power alarm disabled.
Power-up Mode
Switch SW 8 on the configuration switch defines the power up mode on
NxN square routers, and enables input extension on 16x2 routers. The
Triton Plus router provides two modes for powering up the system.
The power up options can be switched according to the following pattern
given in
Table 29 :
Default setting switches all outputs according to the buffered information
in the routers processor system.
Configuring Output on Single Bus Panels
Refer to Input on page 30 for configuring default output to be controlled
from a single bus control panel.
Table 28. SW 7 – Power Alarm
SW 7 Power Alarm
Off Disables power alarm
On Enables power alarm
Table 29. SW 8 – Power Up Mode
SW 8 Power Up Mode
Off
Switches all outputs according to the buffered information in
the routers processor system.
On Switches all outputs to input 1.