Grass Valley Profile Enhanced Disk Recorder - Manual (Page 37)

Installation Verification
Enhanced Disk Recorder Installation 29
Installation Verification
Installation verification of a board you have added to your Profile system consists of
using the Diagnostics window to ensure that the system recognizes the board. Use the
following procedure to check for recognition of the Slave EDR board you just installed:
1. From the Windows NT 4.0 desktop, open the Diagnostics window by choosing
Start | Programs | PDR Debug Tools | PDR Diagnostics.
2. Ensure that the Slave EDR board appears in the slot where you installed it.
Figure 13 is an example of what would appear in the Diagnostic window if all the
boards shown in Example 2 (page 14) were actually installed.
Figure 13. Example Diagnostics Window Display
This completes the installation of the Profile Enhanced Disk Recorder board.
Slot J1
Slot J2
Slot J3
Slot J4
Slot J5
Slot J6
Slot J7
Slot J8
Slot J9
Slot J10
Slot J11
Slot J12
Slot J13
Slot J14
Slot J15
Slot J16
Slot J17
Mother Bd
Quit
Mother Board
Serial Digital I/O
ASPB
Master EDR
Slave EDR
FibreChannel