Grass Valley Profile Enhanced Disk Recorder - Manual (Page 30)

Enhanced Disk Recorder Installation
22 Enhanced Disk Recorder Installation
5. Using a Torx tool with a T15 tip, install the two mounting bracket screws: one that
anchors the top of the bracket from inside the chassis (
Ê in Figure 8) and one that
anchors the bottom of the bracket from the outside rear panel of the chassis
(
Ë in Figure 8).
Figure 8. Installing the Board Mounting Bracket Screws
6. If necessary, install the blank circuit board brackets in the empty board slots on the
rear panel of the chassis.
7. Reconnect any audio clock cables previously removed. Refer to “Audio Clock
Cabling” (page 16) if you need help determining cable connections.
8. Using a Torx tool with a T10 tip, reinstall the rear board hold-down bracket. See
Figure 2 (page 5).
CAUTION: To prevent damage to a Monitor board, if installed, do not install a short
board extension on the front hold-down bracket at the Monitor board location.
9. If necessary, reconfigure the front board hold-down, moving or removing a short
board extension.
10. Using a Torx tool with a T10 tip, reinstall the front board hold-down bracket. See
Figure 2.
9040-13
1
2
!