Grass Valley Profile Enhanced Disk Recorder - Manual (Page 29)

Installing the Slave Enhanced Disk Recorder Board
Enhanced Disk Recorder Installation 21
Installing the Slave Enhanced Disk Recorder Board
The following procedure explains how to install the Slave EDR board:
1. Disconnect the SCSI cable from the Master EDR board (
Ê in Figure 7). Note that
there are two SCSI cables to disconnect if your system has eight hard drives.
2. Determine which slot the Slave EDR board will be using. Refer to Table 1
(page 8). If you aren’t sure how to interpret Table 1, read the section titled “Board
Location Guide” (page 7).
3. If necessary, remove the slot cover where you want to install the board.
4. Align the board with the connectors on the motherboard, making sure the extractor
on the front end of the board is in the up position. Firmly press down on the board
(
Ë in Figure 7) until the board seats. The board is properly seated when the top of
the rear mounting bracket is resting on the rear chassis wall shelf.
Figure 7. Installing the Slave EDR Board
9978-1
1
1
2
Slave EDR Board
Master EDR Board