Grass Valley Profile Enhanced Disk Recorder - Manual (Page 10)

Enhanced Disk Recorder Installation
2 Enhanced Disk Recorder Installation
Tools Required
Tools required, but not supplied, to install this kit are:
• Torx tool with T10 and T15 tips
• 3/16-inch hex wrench
• Electrostatic discharge (ESD) grounding straps
Electrostatic Precautions
CAUTION: This product contains components that are highly sensitive to
electrostatic discharge. To protect these components from damage and to maintain
product reliability, take the following precautions when handling the circuit boards:
• Handle all circuit boards in a static-protected area capable of controlling static
charge on conductive materials, people, and non-conductive materials.
Static-protected areas include non-static table tops and non-static floor mats.
• Handle the circuit boards only by the edges. Avoid touching the printed wires on
the back of the circuit board as much as possible.
• Leave the board in its static-shielded bag until you are ready to install the board.
• Wear ESD grounding straps when handling boards not protected by
static-shielded bags.
!