Grass Valley Profile Enhanced Disk Recorder - Manual (Page 19)

Board Location Guide
Enhanced Disk Recorder Installation 11
Selecting a Location
The following procedure explains how to select a location for a board you want to add
to your Profile system. Use Table 2 (page 10) as a template for recording information
for the new board placement.
1. On Table 2, put a
3 in each input and output block used by every board currently
installed in your Profile system, starting with the 1 block for each board. Look in
Table 1 (page 8) to get this information.
2. Using Table 1, find the input and output requirements, and the recommended slot
and alternate slots (if any), for the board you want to install.
3. On Table 2, complete the following steps:
- In the Board column, next to the appropriate slot number, write the name of
the board you want to install.
- Put an
8 in the appropriate input blocks.
- Put an
8 in the appropriate output blocks.
NOTE: If you can’t find an open slot with an I/O which meets the requirements of
the board you want to install, you will have to move existing boards. You can use
Table 1 and Table 2 to experiment with various board locations before deciding
which board configuration you want to use.
The following examples show how to use the above procedure to select a location for
the Slave EDR board.