Grass Valley Profile Enhanced Disk Recorder - Manual (Page 13)

Removing the Circuit Board Hold-down Brackets
Enhanced Disk Recorder Installation 5
Removing the Circuit Board Hold-down Brackets
There are two hold-down brackets (shown in Figure 2) you must remove to access the
circuit boards. Use the procedure below to remove these brackets.
Figure 2. Removing the Circuit Board Hold-down Brackets
1. Using a Torx tool with a T10 tip, remove the screw (
Ê in Figure 2) which secures
the rear board hold-down bracket.
2. Lift the hold-down bracket (
Ë in Figure 2) out of the chassis and set aside.
3. Using a Torx tool with a T10 tip, remove the screw (
Ì in Figure 2) which secures
the front board hold-down bracket.
4. Lift the hold-down bracket (
Í in Figure 2) out of the chassis and set aside.
9675-2
1
3
4
2