Grass Valley EC9535 v.1.1 - Manual (Page 17)

9
Installation
When setting up an EC9535 GSC Node Bus Converter for the first time, or reconfiguring an
existing configuration, there are certain steps that must be performed. It is recommended that
initial installation and later reconfiguration tasks be performed in a specific order to avoid
possible complications.
Perform installation and reconfiguration tasks in the following order. If you are reconfiguring,
only perform the step related to the configuration you are changing:
1 Mount the EC9535 in a rack. See Rack Mount on page 10.
2 Make connections between the EC9535 and the SMS7000 system controller. See Making Sys-
tem Controller Connections on page 11.
3 Make connections between the EC9535 and the router. See Making Router Connections on
page 12.
4 Make diagnostic connections. Diagnostic connections enable the router and UniConfig to
communicate. This is important when initially configuring the router and any time the router
is reconfigured. See
Making Diagnostic Connections on page 13.
5 Connect the alarm connection on the router to an external indicator. See Making System
Alarm Connections on page 15.
6 Connect power. See Connecting to Power on page 16.
7 Install UniConfig. If reconfiguring, UniConfig does not need to be reinstalled. See the Uni-
Config User’s Guide.
Package Contents
When your EC9535 products from Grass Valley arrive, immediately inspect the shipping
container for any obvious damage. If the container is damaged, unpack and inspect the
contents. If the contents are damaged, notify the carrier immediately.
When unpacking the shipping container, look for the packing slip and compare it against the
contents to verify that everything ordered was received. If anything is missing (or if equipment is
damaged unrelated to shipping), please contact Miranda. For contact information, see
Grass
Valley Technical Support on page 35.
The package does not contain a mounting rack, network cables, mounting screws, or grounding
wire.