Grass Valley NV9648 v.1.1 - Manual (Page 81)

71
NV9648
User’s Guide
Setup Mode
Setup mode occurs when the NV9648 is disconnected from its network and is freshly powered
up. In setup mode, you can set or change the panel ID, identify the software version, and
perform a test of the panel’s buttons. It is in setup mode that you must initially set the panel ID.
 It can take several seconds for the buttons to appear.
Panel ID
The panel powers up with a “menu” button illuminated in green and a display of the current
panel ID. The panel ID is usually set to 0 at the factory:
Press the menu button to proceed to the first part of setup which is to set the panel ID:
The buttons on the left side of the panel light up and form a numeric keypad. Enter a panel ID
(up to 8 digits) by pressing the appropriate numerical buttons:
Press ‘Clear’ at the lower right if you make a mistake. Then enter the panel ID again.
Press ‘Save’ to accept the new panel ID and to exit the panel ID entry submenu.
Press the ‘Exit’ button to leave the submenu without making a change.
Software Versions
Press the ‘Software Versions’ button to display the panel’s software and firmware versions. The
software part number and its revision number wrap around the first two lines of the display. In
NV9648 NV9648
PANEL ID PANEL ID
6481 6481
ACQUIRE ACQUIRE
IP IP
ADDRESS ADDRESS
MENU MENU Menu button
ENTER ENTER
PANEL ID PANEL ID
SOFTWARE SOFTWARE
VERSIONS VERSIONS
PANEL PANEL
TEST TEST
MODE MODE
EXIT EXIT
NV9648 P a n e l I D 6 4 8 1
1 1 2 2 3 3
4 4 5 5 6 6
7 7 8 8 9 9
0 0
PANEL ID PANEL ID
123 123
CLEAR CLEAR SAVE SAVE EXIT EXIT