Grass Valley NV9648 v.1.1 - Manual (Page 77)

67
NV9648
User’s Guide
Procedure B — Preset a Source Using a Keypad
To preset a source in the preset display of the NV9649 (server):
1 Ensure that the NV9649 is in source mode. Press a ‘Source Mode’ button or press a ‘SRC/DST
Mode’ button when the panel is in destination mode.
2 Use a category button to select the desired category. The selected category will be displayed
in the preset display. (The panel must have been configured with one or more category but-
tons.)
3 After choosing a category, use the panel’s keypad to “type in” the index of the desired device
contained in the category. For example, if the category is VTR and the device is VTR_12, type
in 1, then 2. (The panel must have been configured with one or more suffix buttons, which
are category buttons that provide suffixes.)
As you press keys of the keypad, a device that currently matches the string of indexes will be
displayed in the ‘Preset’ display.
Note also that you can use the knob to scroll forward or back from any point in the device
selection (starting at that whatever index you have entered so far).
 During device selection by keypad, certain keys in the keypad become disabled if it is not
possible to use the keys to perform further selection. For instance, if you have devices
numbered 1–16 in a category and you press 2 (e.g., VTR2), all keys in the keypad become
disabled because another digit would create an index of 20, 21, or similar, which is
beyond the range of 1–16.
4 At any time, you can press a ‘Clear’ button to go back one key press at a time as you require.
Procedure C — Assign a New Source to a NV9648 Source Button
To assign a new source to a source button of an NV9648’s control unit:
1 Ensure that the NV9649 is in source mode. Press the ‘Source Mode’ button or press a ‘SRC/
DST Mode’ button if the panel is in destination mode.
2 Use procedure A or procedure B described above to select (i.e., preset) the desired source.
3 Press an ‘Assign’ button on the NV9649.
4 Press the intended source button — in the intended control unit of the intended NV9648.
The software assigns the source selected at the NV9649 to that button. The source text
appears on the button’s LCD.
Procedure D — Assign a New Destination to a NV9648 Control Unit
To assign a new destination to a control unit of an NV9648:
1 Ensure that the NV9649 is in destination mode. Press the ‘Destination Mode’ button or press
a ‘SRC/DST Mode’ button if the panel is in source mode.
2 Select a destination device by (1) turning the knob or (1) selecting the category and device
index using a “keypad.”Use the method described under procedures A or B. But because you
have placed the NV9649 in destination mode, the method selects a destination.
3 Press an ‘Assign’ button on the NV9649.
4 Press any source button in the intended control unit of the intended NV9648. (To help you do
this, the source buttons of NV9648s — and only the source buttons — will be lighted.)