Grass Valley NV9648 v.1.1 - Manual (Page 21)

11
NV9648
User’s Guide
A second power connection is for redundancy only (protection against failure) and is not a
requirement for operation.
Refer to Power Specifications on page 81 for details on the PS0001 power supply. See also
Power Cord Retention on page 87.
4 Connect tally (GPIO) input devices and output devices at the DB25 GPI connector.
You can use the optional WC0053 breakout cable to make these connections.
See chapter 6, GPIO , on page 75 for detail regarding the tally interface.
Installing Software and Documentation
This document is available through the Grass Valley web site.
You must use NV9000-SE Utilities to configure the NV9648 control panel. Contact Grass Valley if
you need to obtain the latest version of this NV9000 configuration software.
You may use the Panel IP Configuration Utility if you want to your NV9648 to have a static IP
address (with respect to the NV9000) or to use DHCP. The panel, as it comes from the factory,
defaults to DHCP.
Initialization
Before your NV9000 system controller can communicate with an NV9648, you must give it a
panel ID. Follow these steps for each NV9648 you are installing:
1 Power up the NV9648. Do not connect its Ethernet cable. (Disconnect it if it is connected.)
After a few seconds, the display will show ‘Acquire IP Address’ at the top left and show the
panel’s current panel ID:
The menu button, with which to access the setup functions, is at the lower right.
2 Press the menu button. The panel now displays a menu of 3 items:
Press ‘Enter Panel ID’ to go to the panel ID menu. Or press ‘Exit’ to leave the menu.
NV9648 NV9648
PANEL ID PANEL ID
6481 6481
ACQUIRE ACQUIRE
IP IP
ADDRESS ADDRESS
MENU MENU
ENTER ENTER
PANEL ID PANEL ID
SOFTWARE SOFTWARE
VERSIONS VERSIONS
PANEL PANEL
TEST TEST
MODE MODE
EXIT EXIT