Grass Valley KALEIDO-IP X300 v.7.80 - Manual (Page 25)

13
Kaleido-IP X300/X100
Quick Start Guide
a Click Configure, under DNS and proxy configuration.
The DNS and Proxy Configuration page appears.
b Type the appropriate suffixes for your primary domain, and search domain, and the
IP addresses for the primary, and secondary DNS server.
c Select Enable proxy, and then type the URL of the appropriate proxy auto-config
(PAC) file, if required.
d Click Apply configuration.
A message appears confirming that the changes have been applied.
e Click OK to dismiss the message.
19 If this system must monitor sources from a VLAN environment, then refer to Configuring
Virtual Network Adapters on a Kaleido-IP, in the Kaleido-X User’s Manual, to add the
required virtual network adapters.
Finding the Management IP Address and Application Version
To find the management IP address and application version
1 Connect a mouse to a USB connector: either at the front of the frame, or on the rear
panel.
2 Right-click anywhere on the monitor wall. On the shortcut menu, point to Monitor Wall
(if you clicked a monitor), and then click Show dashboard to display the dashboard
associated with the current head. A small window appears in the bottom-right area,
revealing the management IP address and the system version. Take note of these
values.
Configuring a Client PC
The client PC that you will use to communicate with the Kaleido-IP multiviewer (via XAdmin
and XEdit) and the multiviewer’s gigabit Ethernet port associated with the management
network must have IP addresses within the same subnet. The following procedure applies
to a typical Windows 7 or Windows 8 system. For Windows XP, see
Changing an IP Address
on Windows XP , on page 15.