Grass Valley KALEIDO-IP X300 v.7.80 - Manual (Page 23)

11
Kaleido-IP X300/X100
Quick Start Guide
9 Under General, type a different name for your system if you wish.
If there are more than one multiviewer in the same network environment, it is
important to assign each a unique system name, so that you can tell them apart (for
example, when using a remote control panel such as the Kaleido-RCP2 or RCP-200).
10 Under Ethernet, type the appropriate IP addresses, network masks, and gateway
settings, and review the detected connection speeds and duplex modes for your
Kaleido-IP’s network adapters.
Note: In the case of a Kaleido-IP multiviewer, the system name must
comply with RFC 1123, because it is also used as the device’s host name. Up
to 8 characters are allowed, limited to A-Z, a-z, 0-9, and the hyphen. The
system name cannot start or end with an hyphen.
Management IP
address Must be within the network to which the Kaleido-RCP2 units, and
the operators’ PCs or laptops are normally connected.
Data port The IP address for a data port must be within the same range as the
associated streaming devices (e.g. encoders, multiplexers).
To omit network configuration for an unused data port, clear the
corresponding Enabled check box.
Network mask Must be set to the appropriate values, for the management and data
networks.
Default gateway If your management network is not configured with a gateway, clear
the default gateway IP address.