Grass Valley KALEIDO-IP X300 v.7.80 - Manual (Page 21)

9
Kaleido-IP X300/X100
Quick Start Guide
The Kaleido-IP is shipped with the following default settings.
To change the Kaleido-IP’s management and data IP addresses
1 Configure your client PC or laptop with an IP address in the same range as the current
management IP address of the multiviewer (see Configuring a Client PC , on page 13).
2 Open a Web browser window and type your multiviewer’s management IP address in
the address bar.
3 The multiviewer’s home page appears.
Kaleido-IP default IP settings
Kaleido-IP-6 Kaleido-IP-4 Kaleido-IP-2
Management IP address (LAN1) 10.0.3.70 10.0.3.70 10.0.3.70
Network mask 255.255.0.0 255.255.0.0 255.255.0.0
Default gateway 10.0.0.1 10.0.0.1 10.0.0.1
Link mode Auto-negotiate Auto-negotiate Auto-negotiate
Data port 1 IP address (LAN2) 172.30.3.70 172.30.3.70 172.30.3.70
Network mask 255.255.0.0 255.255.0.0 255.255.0.0
Link mode Auto-negotiate Auto-negotiate Auto-negotiate
Data port 2 IP address (LAN3) 172.30.3.71 172.30.3.71 —
Network mask 255.255.0.0 255.255.0.0
Link mode Auto-negotiate Auto-negotiate
Data port 3 IP address (LAN4) 172.30.3.72 172.30.3.72 —
Network mask 255.255.0.0 255.255.0.0
Link mode Auto-negotiate Auto-negotiate
Data port 4 IP address (LAN5) 172.30.3.73 — —
Network mask 255.255.0.0
Link mode Auto-negotiate
Data port 5 IP address (LAN6) 172.30.3.74 — —
Network mask 255.255.0.0
Link mode Auto-negotiate
Note: If the management IP address of your Kaleido-IP has been changed
(i.e. it no longer corresponds to the as-shipped configuration), it is still
possible to determine the current management IP address setting. See
Finding the Management IP Address and Application Version on page 13.