Grass Valley K2 InSync v.4.0 - Manual (Page 14)

14 K2 InSync User Guide August 4, 2008
Using K2 InSync
following:
- Volume (such as EXT:
- Bin (such as default)
- Clip Name
• Type — Select Include or Exclude to specify how K2 InSync should treat the
Filter criteria.
• Duration — Select Is Less Than , Is More Than , or Is Between two given times.
Enter Hours:Minutes:Seconds.Frames to define the length of the clips to
synchronize.
• Creation Date Time — Select Is Earlier Than , Is Later Than , or In Between two
given times. Enter dates and times to define the age of the clips to synchronize
or select from the drop-down list.
• Last Modified Date Time — Select Is Earlier Than , Is Later Than , or In Between two
given times. Enter dates and times to define the time last modified of the clips
to synchronize or select from the drop-down list.
• Encoding Format — Select the format-type of the clips to synchronize: MPEG or
DV . If you want to synchronize both format-types, do not select this filter setting.
• Resolution Format — Select the resolution type to synchronize: SD or HD . If you
want to synchronize both types, do not select this filter setting.
6. Select filters in the Filters list and use the Add, Duplicate, Delete, and Rename
buttons as necessary to create your required list of filters. For example, you could
duplicate and rename a filter several times and for each duplication de-select some
of the filter settings or otherwise modify certain parameters so as to create a series
of “windows” for tight control of the clips to be synchronized. You can have a
maximum of ten filters in the list. All filters in the list are processed when
synchronization occurs.
7. When you are satisfied with your settings, click Apply to put settings into effect and
leave the dialog box open, or click OK to put settings into effect and close the dialog
box. When you click OK, the following occurs:
• If the manual synchronization mode is currently selected, no synchronization
processes begin.
• If event, periodic, or timed synchronization mode is currently selected, a
synchronization process might begin, depending on other settings. Refer to
“Running synchronizations” on page 15 .
Saving a configuration file
The default configuration file is stored at C:\InSync.cfg. This default configuration
file is updated whenever you modify K2 InSync configuration, unless you
intentionally save a configuration file with a specific name or location, as explained
in this procedure.
You can create and save multiple configuration files, as follows:
1. Configure settings as in “Setting master and slave K2s” on page 8 , “Configuring