Grass Valley K2 InSync v.4.0 - Manual (Page 13)

August 4, 2008 K2 InSync User Guide 13
Defining filters
8. When you are satisfied with your settings, click Apply to put settings into effect and
leave the dialog box open, or click OK to put settings into effect and close the dialog
box. When you click OK, the following occurs:
• If the manual synchronization mode is currently selected, no synchronization
processes begin.
• If event, periodic, or timed synchronization mode is currently selected, a
synchronization process might begin, depending on other settings. Refer to
“Running synchronizations” on page 15 .
Defining filters
You can define a filter by which K2 InSync only processes certain files during
synchronization, as follows:
1. Click Config | View . The Configuration dialog box opens.
2. Click the Filter tab.
3. Click Add . A filter name appears in the Filters list. Change the filter name to a name
of your choosing.
4. With your new filter still selected in the Filters list, select the filter settings to
include in that filter. As you select the check box for a filter setting, its parameters
become enabled for modification.
5. For your selected filter settings, modify parameters as follows:
• Path — Clips in the path are synchronized. Clips outside the path are not
synchronized. Make sure that the path defined here is in “Master”, as defined on
the General tab. Define the path by entering, in order, one of more of the